S&W M&P Trigger Job
Standard Trigger job- $65.00 plus return shipping
Smoothes out and reduces pull weight to as low as 3.5 pounds on the M&P40 or M&P9, 4.5 pounds on the M&P45. Reduces reset and over travel. Makes significant improvement over stock trigger. Is absolutely not mushy like a glock with a 3.5 pound connector. I do not change any springs so you not need to worry about light primer hits. This is about as close to a 1911 trigger as you can get without a 1911. No safeties are disabled in any way. I can do the standard trigger job without really reducing the trigger pull weight for those more comfortable with heavier trigger.
Competition Trigger job- $110.00 plus return shipping
Smoothes out and reduces pull weight to 2.25 pounds. reduces reset and over travel. I do not change the striker spring so you not need to worry about light primer hits. This trigger is a little less crisp than the Standard Trigger job but is about the same as stock.
In addition to the above trigger jobs I offer a couple options
1. Pre-travel adjustment- this moves the trigger bar back against the drop safety. This removes as much of the pre-travel as possible while maintaining all the safeties.
2. Welded over-travel- I remove the over-travel by welding up a travel stop inside the gun, this will make the trigger break further away from the frame. This works very well for people with a long reaching trigger finger.
* I can work with you if you have some specific requirements for trigger jobs
S&W M&P Grip Enhancement
Front Strap $35.00 plus return shipping
Back Strap $35.00/per customer supplied insert plus return shipping
Forward Index points $10 each side
Trigger face $15
When doing the front and back strap together I also do the Magazine release and the Striker cover, there is no extra charge for this.
Also please let me know if your weapon is going to be used for USPSA production, if so I will not do the mag release or the strike cover.
S&W M&P Grips
Shark skin replacement grips- Click here to order
Other M&P Add-ons
Bobtail treatment- Removal of the stock beavertail- $35
Front Sight- $15 to install your sight to center of slide.
Rear Sight- Installation of any M&P rear sight $10 (there is no charge if done at the same time as a trigger job)
Please email all questions. I can call you back, but with my other job I can usually answer emails quicker than return phone calls.